In getting ready to remove Center stand and remove rear linkage for service. Before I do, can someone tell me the size and length of the two bolts I will be cutting off. I’d like to pick them up before I get started. I can reuse lock nuts if you also know the thread pitch. Thanks
Sawsall Center stand bolts
Mooseman1.
21 - 23 of 23 Posts
Mortenk
thanks for the coin suggestion. 26 Canadian Nickels is what it took! Bike was back on main stand after greasing suspension. Using a spring hook would be nice but you can’t pull down when working on the floor. I’m 71 now and if I was 25-30 I could have bare handed with a screw driver. For us old folks, nickels strategicley placed worked great. Also flipping front foot pegs over to install jackstands was another helpful suggestion I got on the forum. Thanks everyone, it was a dirty job but it’s done. Ready to ride now.
thanks for the coin suggestion. 26 Canadian Nickels is what it took! Bike was back on main stand after greasing suspension. Using a spring hook would be nice but you can’t pull down when working on the floor. I’m 71 now and if I was 25-30 I could have bare handed with a screw driver. For us old folks, nickels strategicley placed worked great. Also flipping front foot pegs over to install jackstands was another helpful suggestion I got on the forum. Thanks everyone, it was a dirty job but it’s done. Ready to ride now.
21 - 23 of 23 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
