FJR Owners Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
If someone has Power Commander III and enabled Accelerator Pump settings, what setting you have used?
I have my own PC3 map tuned in dyno + LeoVince and I just enabled Acc pump with sligthly modified race settings (75% sensitivity, 20% increase, 20 cycles). I could notice some good impact on top of my dyno map. Really fun to play with the throttle without too light front wheel.
 

·
Registered
Joined
·
24 Posts
Discussion Starter · #3 ·
Rabbit1300 said:
Thanks, at least a couple of settings found; somewhat in middle of race and street settings. To summarize, I have found following (sensitivity/fuel increase/engine revolutions)
PC3 Street: 90%/15%/20
PC3 Race: 75%/20%/15
Tiiikeri: 85%/20%/15
Knightowl 90%/20%/15 (?? as claimed to be street. Numbers correct?)
Anttoo: 75%/20%/20
 
1 - 3 of 3 Posts
Top