FJR Owners Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
My 2001 centre stand just failed. Luckily it was as I was trying to lift the bike, not when it was down! Has anyone had experience in fitting a Gen 2 stand to a Gen 1 bike? These seem much easier and cheaper to obtain in the UK than the later reinforced Gen 1 stand.
 

·
Premium Member
CBF1000 VFR800
Joined
·
8,279 Posts
All you can do is try one..... I can't imagine the mounting is much different. The difference might be in the overall height as you do have a slightly shorter swingarm. 2013-up was a little shorter than Gen2 (easier to get it up), and same mounting.

Thought..... you can keep your existing mounts and perhaps just change out the stand if the width is the same on both.
 
1 - 2 of 2 Posts
Top