FJR Owners Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

41 - 44 of 44 Posts

·
Premium Member
CBF1000 VFR800
Joined
·
8,405 Posts
Us old HF users made protectors for those HF rim-scratchers... or bought Mojo blocks...
 
  • Like
Reactions: Whooshka

·
Registered
Joined
·
56 Posts
Discussion Starter · #42 ·
I've been doing a little more homework on this. Think I'm going to give it a try next time around. If I get 6-8 tire changes in, I'll be even. Not bad IMO. Plus like mentioned earlier, can always post here for help - Heads up! :)
 

·
Registered
'15 FJR1300A
Joined
·
209 Posts
<quote>I've already got a steel threaded rod that is the proper diameter for the bearings - oddly enough the correct thread to screw into the base where the factory bar screws in. This allows me to hold the wheel down by the hub and not have to use the rim gouging clamps to keep it from moving. That being said, it is quicker to just do it on the floor.<quote>

Can you share the thread pitch or where you got the threaded rod?
 
41 - 44 of 44 Posts
Top