Yamaha FJR Forum : Yamaha FJR Owners Forums - Reply to Topic
Thread: ABS test fail now won't start! A WTF moment Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Yamaha FJR Forum : Yamaha FJR Owners Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
08-16-2019 06:36 PM
aussi dave HAHA be careful or it will be the finish of a conversation!
08-16-2019 09:50 AM
RaYzerman When my wife said "you weren't even listening to me, were you?", I thought "that's a strange way to start a conversation".
08-16-2019 03:52 AM
aussi dave OK Brains Trust here's the suprise ending.

SO I check all the wiring I had moved... all ok.

Try start up at full throttle, no go.

Then my wife says, 'what about that loose wire to the battery last time it wouldn't start and I said where does that go?' and I still don't know what it is but I went looking for it and it had fallen down inside the fairing. Its an earth wire which I now think is B/Y and links the clutch to the starter cutoff relay, diverted directly to the neg terminal by a service mechanic once. That's my guess but I'm relying on female intuition here.

SO now I connect this lonesome wire to the neg terminal and BINGO ALL SYSTEMS GO, including ABS RED LIGHT OFF!

Dunno why it seems to have fixed itself.. prob got sick of my faffing round.

SO thanks again for all the advice, mine would just be get your significant other to check it out and deliver the non-linear, lateral thinking verdict before you spend days pulling all the tupperware off the thing. I swear my next bike will be naked or at best a half fairing! I'm racing a little '92 honda CBR400RR and the glass comes off in about 2 minutes! Way to go.

thanks again.

AD
08-15-2019 05:52 PM
aussi dave
Quote:
Originally Posted by RaYzerman View Post
Back to my earlier question, does the fuel pump cycle when the ignition is turned on? If so, then it could be the cold start issue.... use a booster battery as well, FJR needs good voltage supply to run things.
Yep sure does. So I'll give the full throttle another go and switch to a second battery if the installed one flags.
08-15-2019 07:10 AM
RaYzerman Back to my earlier question, does the fuel pump cycle when the ignition is turned on? If so, then it could be the cold start issue.... use a booster battery as well, FJR needs good voltage supply to run things.
08-15-2019 01:56 AM
aussi dave Thanks guys. tried cranking at full tilt until battery was going south, no good. ABS light now goes off after initial few seconds but comes on again when I try to start. Fuses all ok so I'm thinking its time to walk through all the wiring I've been disturbing, pull apart every connection, clean and put back, and look for gaps in wiring, and spiders / earth wires especially. Onward down the fixit highway!
08-14-2019 10:45 PM
red
ABS test fail now won't start! A WTF moment

Quote:
Originally Posted by rbentnail View Post
See attached
Dave,

Corrosion or a wire fault at the ABS wheel sensor is one possible cause of the warning light problem, then.

Running in gear on the centerstand can cause a false warning light indication, with no real problem.
Sometimes an ABS light will sort itself out with normal riding, maybe in 15 minutes or so.
.
08-14-2019 10:27 PM
Polar It should start with a tps fault but be a bugger to ride cutting out at junctions, never known an fjr not to run because of the tps fault.

Have you tried cranking with the throttle wide open as suggested?
08-14-2019 07:19 PM
rbentnail See attached
08-14-2019 07:00 PM
aussi dave Thanks the code 16 came up. my version of the shop manual does not have general diag codes... what is 16?
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome