2016 Canyon Cage removal, replacement bolts
I bought a used 2016 FJR1300A that came with Canyon Cages. I don't care for them, so I've removed them. Of course, the PO didn't include the removed hardware so I've been going to Partzilla and picking up bolts and nuts as needed. All was well until the last bolt. The frame cages replace the motor mount bolts, both front and rear. The front were straightforward, but the rear have turned out to be a problem. Looking at the manual pg 5-8 I believe the correct bolt is "19 - Engine Mount Bolt (rear upper side)". On the Partzilla diagram, I think this is part 20 "BOLT, FLANGE 90105-10781-00".
Problem is that this bolt is about an inch short. Anyone have any ideas? Is that the right bolt? I double checked the part number they sent and it matches the page.
Any suggestions would be appreciated.